Reasons Why Your Heater is Not Working Even When The Thermostat is on
The Blower Capacitor is Dead
The capacitor starts the furnace after the temperature setting on your thermostat instructs it to start. Each capacitor has a tolerance. If the tolerance level is less than a certain threshold, the blower might not be able to achieve the proper RPM. Sometimes the capacitor cannot start the blower. You can also call one of our heating repair specialist in Antelope valley to replace it.
A Lack of Maintenance Could Be The Cause of Your Heater Not Perating
The most common reason homeowners contact our heater repair technicians in Antelope valley in the winter is the absence of maintenance for their furnaces. If your furnace isn’t turning on, it’s usually because it hasn’t been tuned for a while. Most often, the problem is that the heating system is dirty.
If your furnace is dirty, it could cause the equipment to fail. Dirty filters could be the reason why your heater isn’t functioning. This is why it’s important to change filters at least every three months.
Inadequate tuning may cause an unclean flame sensor. Sensors covered with gunk are cut off at the time it turns on because it isn’t able to detect the flame. Sometimes it’s the burners that are dirty after long periods of inactivity.
The Refrigerant Levels Aren’t High Enough
If you’re heating your home with a heat pump, the system’s refrigerant levels can become too low. This means that the heat strips continue to come on and off, which can lead to significant energy bills.
If refrigerant levels stay low for a prolonged period, the compressor may overheat and fail. Call a heating repair technician in Antelope valley as soon as possible, as it’s much less expensive to refill your refrigerant or repair leaks than to replace the compressor.
Check For Obstructions in The Ducts That are Preventing Airflow
If two or three rooms are cold, and the furnace is on and running in other rooms, look over the ductwork and check for a gap between the sections and branches. Fill any gaps using quality duct tape. Be sure not to apply standard duct tape because it could cause ducts to leak.
Check Your Furnace Ignition Switch
If the above steps don’t work, you must check the ignition. It is best to undertake this task only if you’re proficient in electricity and have a good grasp of home-based projects. If you’re unsure about your DIY skills, do not take this step and get in touch with our experienced heater repair specialists in Antelope valley to assist you.
If you’re experiencing heating issues and feeling like you’re at the North Pole in your own home, reach out to Econo West Heating Air & Plumbing at 661-947-2653 or send an email for assistance. One of our knowledgeable technicians will pinpoint the problem and provide you with the most effective alternatives for replacement or repair according to your budget and your needs.
